If a Cisco entity is not assigned a PID, that entity is not retrieved or displayed.
#Cisco udi password#
Enter your password if prompted.Įnter the show inventory command to retrieve and display information about all of the Cisco products installed in the networking device that are assignedĪ PID, VID, and SN. Perform this task to retrieve and display identification information for a Cisco product.Įnters privileged EXEC mode.
#Cisco udi how to#
How to Retrieve the Unique Device Identifier Provides a mechanism to determine the entitlement level of a Cisco product for repair and replacement service. Identifies PIDs for replaceable products.įacilitates discovery of products subject to recall or revision.Īutomates Cisco product inventory (capital and asset management). Reduces operating expenses for asset management through simple, cross-platform, consistent identification of Cisco products. Identifies individual Cisco products in your networks.
#Cisco udi serial number#
This is the means by which to identify an individual, specific instanceįor the following platforms, the UDI is the Printed Circuit Board Number (PCB), and not the chssis Serial Number (SN):īenefits of the Unique Device Identifier Retrieval Feature Each manufactured product will carry a unique serial number assignedĪt the factory, which cannot be changed in the field. The SN is the vendor-unique serialization of the product. The VID is incrementedĪccording to a rigorous process derived from Telcordia GR-209-CORE, an industry guideline that governs product change notices. Whenever a product has been revised, the VID will be incremented. This is the identifier that one would use to order an exact replacement part.
The PID is the name by which the product can be ordered it has been historically called the “Product Name” or “Part Number.” The UDI information is printed onĪ label that is affixed to the physical hardware device, and it is also stored electronically on the device in order to facilitateĪ UDI consists of the following elements: MostĬisco entities that are orderable products will leave the factory with an assigned UDI. An Ethernet switch might be a member of a superentity like a stack. Such as a chassis, will have subentities like slots.
Information About Unique Device Identifier Retrieval The five Entity MIB v2 (RFC-2737) objects are as follows:Īlthough the show inventory command may be available, using that command on devices that are not UDI-enabled will likely produce no output. A UDI-enabled Cisco product supports five requiredĮntity MIB objects. In order to use UDI retrieval, the Cisco product in use must be UDI-enabled. Prerequisites for Unique Device Identifier Retrieval
#Cisco udi software#
Use Cisco Feature Navigator to find information about platform support and Cisco IOS software image support. Software images for Cisco 12000 series Internet routers have been deferred to Cisco IOS Release 12.0(27)S1.įinding Support Information for Platforms and Cisco IOS Software Images This feature was integrated into Cisco IOS Release 12.2(18)SXE5. This feature was integrated into Cisco IOS Release 12.2(27)SBC. This feature was integrated into Cisco IOS Release 12.2(25)S. This feature was integrated into Cisco IOS Release 12.0(27)S. History for Unique Device Identifier Retrieval Feature Information from any Cisco product that has electronically stored such identity information.
The Unique Device Identifier Retrieval feature provides the ability to retrieve and display the Unique Device Identifier (UDI)